● Hardware arm · exploratory
Real Wi-Fi faults on two Arduino UNO Q boards.
Emulated network faults are clean: a proxy adds exactly 300 ms, or drops exactly 5% of packets. A real radio link fails messily. The hardware arm routes one link of the shop over real Wi-Fi, degrades it, and asks whether models read it the way they read the emulated version ("emulation validity"). It is reported next to the main results, outside the hypothesis tests.
edge-relay, a small Go program run by systemd, carries every checkout → payment request over the board's real Wi-Fi. Faults: transmit power dropped to 1 dBm, or the radio switched off for 30 s.
Board A, the relay
A small Go program, edge-relay, runs as a systemd service on the board's Linux side. In the hardware wiring, checkout sends its payment requests to the board, which forwards them over Wi-Fi to payment on the PC.
Sends 30 Mbit/s of UDP with iperf3 to the PC for 5 minutes, crowding the 2.4 GHz channel Board A depends on. Only ever to a private address on the home network.
Board B, the crowd
Runs iperf3 to fill the 2.4 GHz channel with traffic to a server on the PC, and can log signal strength and throughput. The optional demo panel (buttons, LEDs and a small display on the microcontroller) lives here too, for the launch video only.
Wiring
Weak signal Board A's transmit power drops from about 20 dBm to 1 dBm. Its uplink gets lossy; the board puts power back by itself after 8 minutes at the latest.
The three faults
| Fault | Board | What happens | Compared with |
|---|---|---|---|
| hwWeakSignal | Board A | Transmit power to 1 dBm (from about 20 dBm). Reverts by itself after 8 minutes at the latest. | netemLoss |
| hwContention | Board B | 30 Mbit/s of UDP to the PC for 5 minutes on the same 2.4 GHz channel. | toxiLatency |
| hwWifiOutage | Board A | Radio off for 30 seconds, then back on. Replaces unplugging the board by hand. | toxiReset |
Safety and limits
- Own network only
The contention script refuses any server outside private address ranges and points at the PC.
- Undo is built in
Each fault schedules its own revert on the board before it starts, so a lost SSH session never leaves it in place.
- Not the same as distance
Lower transmit power degrades Board A's uplink only. With the board near the router it left no visible trace in the shop's calls.
- Same services as emulated
The relay sent no telemetry of its own, so hardware snapshots show the same services as emulated ones.
Results for the 12 hardware snapshots appear on the home page once they are scored.